Agilent Technologies HSSI WanProbe J3916A - Manual (Page 113)

Probe Operation
Restarting the Probe
93
*PPP refers to PPP, HDLC, or SDLC.
Cycling Power
A power outage or cycling power to the probe causes a warm start. The probe
does not have a power switch; therefore, cycling the power consists of
disconnecting and reconnecting the power cord.
Probe
Configuration
Parameters Trap destination table Saved Reset
Serial connection table Saved Reset
Serial configuration information for
outgoing connections, such as: dial
strings. Saved Reset
Time period for utilization calculations Saved Saved
Other Serial configuration information,
such as: SLIP address and subnet mask,
serial port speed, modem initialization
strings, and Flow Control. Saved Saved
Probe configuration information, such as:
IP address, default gateway, and subnet
mask. Saved Saved
TFTP server address Saved Saved
Download filename Saved Saved
Time zone Saved Saved
Security Settings Saved Saved
Interface Status Saved Saved
Crash data (used by Agilent support) Saved Saved
Category Probe Memory Contents
Warm Start
Status
Cold Start
Status
Table 5-1: Probe Data and Parameters Reset by Warm or Cold Start (Continued)