APPLIED ENGINEERING RamKeeper User Manual

Page 14

To install the RamKeeper, you'll need a Phillips
screwdriver. Once you have it, follow the steps below:

1.) TURN OFF THE APPLE’S POWER SWITCH.

Never install or remove a card while the
computer is on. However, you need to leave the
computer plugged in throughout the installation
to allow the power supply to discharge static
electricity from your body.

2.)

Remove the cover from the Apple. Press in the
two latches in the rear of the case with your
forefingers while using the heel of your hand to
pull the lid up and towards you. (See below.)

3.)

Touch the power supply to remove any static
electricity from your body. Do not skip this step!
A static shock can damage the chips on your
boards and/or the chips on your computers
motherboard.

Remove the IIGS cover

Touch the power supply case

4.) You may want to remove any cards in slots 6 and

7 to give yourself a little more room to operate. If
you do remove any cards, follow the instructions
that came with those cards for removing and
reinserting. Applied Engineering will not be
responsible for any damage to your other cards.

Chapter One - Getting Started