APPLIED ENGINEERING RamKeeper - Manual (Page 12)

Two Memory Cards on RamKeeper
When using two cards with the RamKeeper, the card on
the back side of RamKeeper must have memory in
increments of 512K. So, you can use cards with 512K, 1
Meg, 1.5 Meg (i.e. GS-RAM), 2 Meg, 3 Meg, etc.
The drawings below illustrate the combinations we have
tested and know will work. While other combinations
may work, the combinations below are the ones we
support.
RamKeeper Back Pocket (in 512K increments)
GS-RAM REV C or later
Slot Mover GS-RAM Plus REV 0 or later
All GS-RAM cards GS-RAM 2 Meg Expander
(including 2 Meg Expander) Apple IIGS Memory Expansion Card
RamPak 4GS
Front Connector RamStackPlus
All GS-RAM cards OnBoard
(except 2 Meg Expander) * Due to its large size,
OctoRam will not fit on the
back side of RamKeeper
RamKeeper
Slot Mover Back Pocket
Apple 256K - I Meg Apple 1 Meg
RamStackPlus 256K - 1 Meg RamStackPlus 1 Meg
OnBoard 1 - 4 Meg On Board 4 Meg
OctoRam 256K - 1 Meg (256K chips)
RamKeeper
Slot Mover Back Pocket
RamPak 4GS 512K - 1 Meg RamPak 4GS 4 Meg
OctoRam 1 Meg - 4 Meg (1 Meg chips)
Chapter One - Getting Started 3