Sony CMT-L7HD - Manual (Page 52)

52 GB
3
Select “Search for a suitable driver for
my device (recommended)”.
Load the Windows 2000 CD-ROM into the
CD-ROM drive of the computer if the
wizard requests it, and then install the
drivers. Installation procedure will be
repeated for each of the following device.
• Generic USB hub
Installing the USB driver (Windows
Me)
1
Connect the system to the computer
directly, and then start up the
computer.
“Add New Hardware Wizard” appears.
Quit any applications that are active.
2
Select “Search for the best driver for
your device. (Recommended)”.
Load the Windows Me CD-ROM into the
CD-ROM drive of the computer if the
wizard requests it, and then install the
drivers. Installation procedure will be
repeated for each of the following device.
• Generic USB hub
Installing the USB drivers (Windows
XP)
1
Quit any applications that are active.
2
Connect the system to the computer
directly, and then start up the
computer.
Installation of the drivers starts
automatically, and will be terminated after
completing installation.
If “Found New Hardware Wizard” should
not appear, skip step 3.
3
Select “Install the software
automatically [Recommended]” after
confirming that the name of the device
for which the drivers are to be installed
is “SONY LINK KIT”.
4
Turn on the system.
“Found New Hardware Wizard” appears.
5
Select “Install the software
automatically [Recommended]”.
6
Click “Next”.
If the following message appears, click
“Continure Anyway” to continue with the
procedure.
The installation is completed without a
problem.
If you click “STOP Installation”, the
installation of the drivers is cancelled.
Please note that as a result, the CMT-L7HD
will not connect properly with your
computer.
7
Click “Finish”.
Verifying the status of the installed
devices (Windows 2000/Windows Me/
Windows XP)
Be sure to check the status of the installed
devices after you have installed thier drivers.
1
Open the Control Panel.
In the Start menu, point to “Settings” and
click “Control Panel”.
(For Windows XP) In the Start menu, click
“Control Panel”, and then click “Switch to
Classic View” on the left pane of the
window.
Setup procedure for your computer
system (continued)