Sony CMT-L7HD - Manual (Page 29)

29 GB
HD - Recording
3
Press MENU + or – on the remote
repeatedly until “Setup?” flashes in the
display, then press ENTER/YES on the
remote.
4
Press MENU + or – on the remote
repeatedly until “S.Space On” (or
“S.Space Off”) appears in the display,
then press ENTER/YES on the remote.
5
Press MENU + or – on the remote to
select the setting, then press ENTER/
YES on the remote.
To
Turn on the Smart
Space and Auto Cut
functions
Turn off the Smart
Space and Auto Cut
functions
6
Press MENU/NO on the remote.
Notes
• When you record from a CD, Smart Space does not
affect the order of the track numbers being
recorded, even if the blank space occurs in the
middle of a track.
• Auto Cut is automatically turned on or off in
tandem with Smart Space.
• If the system continues recording pause for about
10 minutes after Auto Cut activated, recording stops
automatically.
• If this function is activated when the 400th track is
reached, recording stops.
• During Auto Storage or High-Speed Synchro
Storage, the Smart Space and Auto Cut functions do
not function.
Select
S.Space On. (factory
setting)
S.Space Off.
Adjusting the recording level
You can adjust the recording level for both
analog and digital recordings.
1
Do steps 1 and 2 of “Recording to the
HD manually” on page 26.
2
Play the portion of the sound source
with the strongest output.
3
Press MENU/NO on the remote.
“Setup?” appears in the display.
4
Press ENTER/YES on the remote.
“Setup Menu” appears in the display.
5
Press MENU + or – on the remote
repeatedly until “LevelAdjust?”
appears in the display, then press
ENTER/YES on the remote.
6
Press MENU + or – on the remote
repeatedly to adjust the recording level
so that the OVER indicator on the peak
level meters does not turn on.
7
Press ENTER/YES on the remote.
8
Press MENU/NO on the remote.
9
Stop playing the sound source.
10
Do step 3 of “Recording to the HD
manually” on page 26.
Tip
To restore the factory setting, press CLEAR on the
remote while adjusting the recording level in step 6.
Notes
• The recording level can only be increased up to
+12 dB (for analog recording) or +18 dB (for digital
recording) (0.0 dB is the factory setting).
Therefore, if the output level of the connected
components is low, it may not be possible to set the
recording level to maximum.
• The monitor sound is not affected when you adjust
the recording level during recording.
• During Auto Storage or High-Speed Synchro
Storage, CD tracks are recorded at the same level as
the original tracks. The adjusted recording level is
not applied during Auto Storage or High-Speed
Synchro Storage.