Depending on the camera and battery temperature, the power may turn off automatically to
protect the camera. In this case, a message is displayed on the screen before the power turns
off.

If you do not operate the camera for a certain period of time while the power is on and [Power
Save] is set to [Standard] or [Stamina], the camera turns off automatically to prevent draining
the battery pack. Turn on the camera again.

If you do not operate the camera for a certain period of time while the power is on and [Power
Save] is set to [Off] or the camera is connected to AC adaptor to supply the power, the screen
automatically goes dark to prevent burn-in on the screen. Touch the screen again to display.

The remaining charge indicator is incorrect.

This is caused when you use the camera in an extremely hot or cold location.

A discrepancy arose between the remaining charge indicator and the actual remaining battery
charge. Fully discharge the battery pack once, then charge it to correct the indication. The
remaining charge indicator may not be correct under certain circumstances.

Battery capacity decreases over time and through repeated use. If decreased usage time
between charges becomes significant, it is probably time to replace it with a new one.

The Power/charge lamp of the camera flashes while charging the

battery.

Check that the battery pack type is NP-BN or NP-BN1.

The Power/charge lamp of the camera flashes infrequently when you use a battery pack that
has not been used for a long time. In such cases, remove the battery pack from the camera
and re-insert it.

239