Avocent CCM - Manual (Page 93)

Chapter 5: CCM Appliance Commands 79
Table 5.31 lists the display fields for a Show Port command (that specifies a single port or All) for
ports that were configured as TD=SPC.
The Show Port Names command displays a list of port numbers and their names. If a port has not
been assigned a name with the Port Set command, the default name is displayed.
The Show Port Groups command displays a list of port numbers and group assignments.
The Show Port Alert command displays a port’s alert strings.
Access * User’s access rights (from User Add and User Set Access commands).
Port Access *
Indicates if a user may connect to the port BY GROUP or BY PORT.
If there is any group defined for any ports (which can be determined with a Show
Port Groups command), each user may connect BY GROUP, unless a user’s access
rights include PALL, in which case, a user may connect BY PORT.
If a user is assigned an empty group (with no ports in it) or no groups at all, that user
may lose access to any port once there is a group defined for any port.
Locked *
Indicates if the port is LOCKED or UNLOCKED. If security lock-out is disabled, N/A
is displayed. See Using security lock-out on page 32 for more information.
Last Login * System up time value when the user logged in.
Duration * Duration of user’s session.
* Displayed only when the command specifies a single port that has a current connection.
Table 5.31: Show Port Command Display Fields for TD=SPC
Parameter Description
Status
ONLINE indicates the SPC device is powered up, OFFLINE indicates the SPC device
is powered down.
Version SPC device firmware version.
Sockets Number of sockets on the SPC device.
Minload Minimum load amp value (from SPC command).
Maxload Maximum load amp value (from SPC command).
Wake Wakeup state for socket (from SPC command).
ON Min Minimum On time (from SPC command).
OFF Min Minimum Off time (from SPC command).
Table 5.30: Show Port Command Display Fields for TD=Console (Continued)
Field Content