Avocent CCM - Manual (Page 92)

78 CCM Installer/User Guide
The display for the console port will not include values for the socket, power, TD, toggle, name or
group fields.
Table 5.30 lists the display fields for a Show Port command that specifies a single port configured
as TD=console. A Show Port All command displays the items listed in the first six rows of the table
(Port through Power fields).
Table 5.30: Show Port Command Display Fields for TD=Console
Field Content
Port Port number.
Serial Port Settings
Comma-separated string of port values: baud rate, number of bits, parity, stop bits,
flow control, socket number, time-out value and CLI access character (from Port Set
command). The CLI character is preceded by POR CLI= if it was defined with a Port
Set command or by SER CLI= if it was defined with a Server CLI command.
TX Bytes Number of bytes transmitted.
RX Bytes Number of bytes received.
Errors Number of TX/RX parity and framing errors.
Toggle Toggle value (from Port Set command).
Power
Device power status, if monitoring is enabled. ON indicates the device is on, OFF
indicates the device is off.
Power Signal
Signal and state being monitored for device power status (from Port Set command).
If monitoring is disabled, this field indicates None.
Port name
Port name assigned with the Port Set command or the default name (last three
octets of MAC address plus the port number).
Group Group names.
Port NFS
ENABLE indicates NFS is enabled, DISABLE indicates NFS is disabled (from Port
NFS command).
File NFS filename (from Port NFS command).
Size threshold NFS size threshold (from Port NFS command).
Time threshold NFS time threshold (from Port NFS command).
Port NFS Status
Status of NFS history file operations. See NFS port status values on page 111 for
more information.
Current file Current NFS filename.
User * Username (from User Add command).
Level * User’s access level (from User Add and User Set Access commands).