Ferguson Ariva TT HD PVR - Manual (Page 71)

71
5. Check the TV activate or not. Go to procedure 6 for activate or repeat procedure
4 for not.
6. Press the [OPTION] key to save the setup on remote control and exit the Search
Mode, then the LED indicator will be turned off.
Remark:
1. During the Search mode, the remote control will be didn’t save the setup and exit
the Search mode if you press any key except the [OPTION] key.
2. The remote control will be exit the Search mode automatically when all codes
was search finish on the database of remote control.
Checking the Brand Code on the remote control
There are 3-digits brand codes for TVs. You can check and show any one of digits
form the following step:
1. Press and hold the [SET] key and press the selected digit of the number keypad,
e.g. [1], [2], or [3].
2. Release both keys and observe the LED on the remote control.
3. The number of LED flashing times is the control code of the selected digit (No
flashing when this digit in zero).
Example: checking the brand code number of in factory setting status.
1. Press the [SET] key at the same time, the LED no flashing --- the 1
st
number is
zero.
2. Press the [SET] key at the same time, the LED flashing once --- the 2
nd
number is
one.
3. Press the [SET] key at the same time, the LED flashing night times --- the 3
rd
number is night.
So the current brand code number is 018
Lock the brand code on the remote control
If the brand code setup was finished. You can use this feature to lock TV device on
the remote control. When after the device Lock has processed, the brand code of the