Ferguson Ariva TT HD PVR - Manual (Page 68)

68
9. USING THE UNIVERSAL REMOTE CONTROL
Before you use the universal remote control to your device what was you want to
control, it must first be programmed (set-up). Please read this guide carefully to make
sure the setup is done properly and that you are getting the most out of your URC101
remote control.
The remote control runs on 2 x AAA batteries. To insert or replace the batteries,
follow these steps:
a) Push the catch on the battery cover upwards and pull the back cover off the main
part.
b) Carefully remove the old batteries then insert the new batteries, matching the +
and – signs.
c) Once the batteries are in, put the cover back on, making sure the catch clicks into
place.
When you are using the remote control, please make sure the information as below:
You point your universal remote control at the infrared part of your device.
Ensure there is nothing blocking the infrared receiver on your device.
Do not leave flat batteries in your universal remote control, as they could leak
and void your warranty.
Always replace the batteries at the same time, do not mix the old and new
batteries or mix different battery types.
When you throw away old batteries, make sure they done in due consideration
with the environment. Please consult your local council or recycle department, for
nearest collection point.
Do not drop or throw your universal remote control, as you may damage the unit
and the circuitry inside.
Do not let the remote control come into contact with any liquids.
Use a dry cloth to clean your universal remote control to make your remote
control last longer.