Ferguson Ariva TT HD PVR - Manual (Page 70)

70
take several minutes to complete. The following instruction uses your television as an
example for set-up using the database Search method.
1. Turn your TV on.
2. Press and hold the [SET] and [TV] key, keep about 3 seconds at the same time
until the LED indicator lights up.
3. Press and release the [CH+] or [CH-] key and the LED indicator will be flashed.
4. Aim the remote control at your TV, please press and release the [CH+] or [CH-]
key slowly, the remote control will transmit the [POWER] Signal of next Table.
5. Check the TV activate or not. Go to procedure 6 for activate or repeat procedure
4 for not.
6. Press the [OPTION] key to save the setup on remote control and exit the Search
Mode, then the LED indicator will be turned off.
Remark:
1. During the search mode, press the [CH+] key set to FORWARD SEARCH, and
press the [CH-] set to BRCKWARD on the database of remote control.
2. During the Search mode, the remote control will be didn’t save the setup and exit
the Search mode if you press any key except the [CH+] or [CH-] key.
3. The remote control will be leaved the Setup mode automatically if you have not
press any key after 30 seconds
QUICK SEARCH the brand code on the remote control
You can use this feature to find out the suitable control code quickly and don’t press
any key. Please use the feature following these steps as blow:
1. Turn on you TV which you want to control.
2. Press and hold the [SET] and [TV] key, keep about 3 seconds at the same time
until the LED indicator lights up.
3. Press and release the [POWER] key to inter the Quick Search mode, and LED
indicator will flash ceaselessly.
4. Aim the remote control at your TV, the remote control will transmit the [POWER]
Signal of next Table automatically.