elektraLite MY 150 - Manual (Page 11)

10
Main functions
- Main menu 0
1. Press
[ENTER] for 3 seconds to enter the main menu "MODE" (display flashing)
2. Press [ENTER] and select "ADDR", “RUN” or "DISP" by pressing [UP] button.
3. Press [ENTER] for selecting the desired sub menu.
- DMX address setting, Slave setting
- DMX address setting
This function, adjusts the desired DMX-address via the display panel.
1. Select “VALU“ by pressing [UP] button.
2. Press [ENTER], adjust the DMX address by pressing [UP] or [DN].
3. Press [ENTER] to confirm.
4. Press [EXIT/DN] to return to main menu.
- Slave setting
This function, defines MY 150 as slave.
1. Select “SLAV” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- No function
- Program Run, Master setting
With the "RUN" function, you can run the internal program. You can set the number of steps under Step.
You can edit the individual scenes under Edit. You can run the individual scenes either automatically
(AUTO), i.e. with the adjusted Step-Time or sound-controlled (SOUN). The selection "ALON" is Stand
Alone-mode and "MAST" sets MY 150 as master.