elektraLite MY 150 - Manual (Page 10)

9
The Display Panel.
The display panel on MY 150 offers many features. For example you can,
1. The starter address can be set. 2. The lamp maybe switched on or off.
3. The fixture maybe reset. 4. The fixture can run a preprogrammed show.
The Main Menu is accessed by pressing the ENTER button until the display starts flashing which will be about
3 seconds. You can scroll through the menu using the UP button. Then use the ENTER button again to select
the menu you want. Confirm every selection by pressing the ENTER button. You can change the selection by
using the UP button and you can exit a sub-menu by pressing the EXIT button.
The features of the display panel are listed as follows:-
Default settings shaded.
Main
menu
Sub menu Extension Display Function
VALU A001~A511 (AXXX) DMX address setting
SLAV ON/OFF (SLAV) Slave setting ADDR
EBOC OFF No functions
ALON (AU-A)
Automatic Program Run
in Stand Alone
AUTO
MAST (AU-M)
Automatic Program Run
as Master
ALON (SO-A)
Sound-controlled Program
Run in Stand Alone
RUN
SOUN
MAST (SO-M)
Sound-controlled Program
Run as Master
VALU
D–00 ~ D-30
(DXXX) Display the DMX 512 value
of each channel
RDIS ON/OFF Reverse display
0 MODE
DISP
CLDI ON/OFF Shut off LED display
OPEN ON/OFF Lamp on/off
ONLI ON/OFF Lamp on/off via controller 1 LAMP
DELA D–00 ~ D-59,D-15 Delay lamp on
RPAN ON/OFF Pan Reverse
RTIL ON/OFF Tilt Reverse
16BI ON/OFF Switch 16 bit/8 bit
REST ON/OFF Reset
LODA ON/OFF Restore factory settings
2 SET
VER V-1.0~V-9.9 Software version
LADJ ON/OFF Lamp adjustment
3 ADJU
TEST T–01 ~ T–30 Test function of each channel
MATI 0000~9999 (hours) Fixture running time
LATI 0000~9999 (hours) Lamp running time
CLMT ON/OFF Clear fixture time
4 TIME
CLLT ON/OFF Clear lamp time
STEP S–01 ~ S–48 Steps of Program Run
C–01 ~ C–30
01XX (00~FFH)
30XX (00~FFH) Edit the channels of each
scene
TIME (sec.) T – – X (1~9) Time for each scene
5 EDIT
SC01
~
SC48
CNIN ON/OFF Edit program via controller