A.J. Antunes & Co VCT-20 9200552 - Manual (Page 8)

8
VERTICAL CONTACT TOASTER
P/N 1010719 Rev. E 02/13
Figure 3. Folding Release Sheet
Lay sheet on a flat surface
Fold over so ends meet
Press lightly with finger to
form crease
Equipment Setup
When placing the toaster into service, pay attention to
the following guidelines.
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
• Connect the unit to the power supply. Refer to
the specification plate for the proper voltage.
Figure 4. Installing Release Sheet
Platen
Conveyor Cover
Conveyor Cover
Heat Shield
Release Sheet
Conveyor Interlock
Switch
WARNING
ELECTRICAL SHOCK HAZARD. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH.
• Electrical ground is required on this appliance.
• Do not modify the power supply cord plug. If it
does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do not use an extension cord with this appli-
ance.
• The toaster should be grounded according to
local electrical codes to prevent the possibility
of electrical shock. It requires a grounded
receptacle with separate electrical lines, pro-
tected by fuses or circuit breaker of the proper
rating.
• Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.
CAUTION
Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe oper-
ating distances may cause discoloration or com-
bustion.
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other applica-
ble codes.
CAUTION
Failure to use release sheets may result in dam-
age to the unit and loss of warranty coverage.
INSTALLATION (continued)