A.J. Antunes & Co VCT-20 9200552 - Manual (Page 13)

13
VERTICAL CONTACT TOASTER
P/N 1010719 Rev. E 02/13
5. Press interlock switch to rotate conveyors (Figure
14). Count to 10, then turn toaster off, and wipe
new section of belt wrap. Re-install the front and
rear cover assemblies.
6. Install the release sheet by draping it over both
sides of the platen with the crease centered
directly on the platen (Figure 10).
7. Install the heat shield (Figure 10). The heat
shield clips fit over the tip of the platen and retain
the release sheet.
Maintenance Schedule
DAILY
1. Turn off power to the toaster.
2. When the toaster is cool, follow the procedures
under Cleaning the Release Sheet and Belt
Wraps.
3. Remove heat shield and bun chute. Wash in
back sink, sanitize and rinse.
4. Wipe down the outside of the toaster and allow to
air dry.
Cleaning the Release Sheet and BeltWraps
1. Turn the rocker switch to off, unplug the unit and
allow it to cool down.
2. Put on protective gloves. Remove heat shield
and release sheet (Figure 10).
3. Wipe release sheet with a clean, sanitized towel.
4. Remove front and rear conveyor cover assys.
(Figure 11). Wipe exterior of belt wraps with a
clean, sanitized towel.
MAINTENANCE
WARNING
Turn the unit off, disconnect the power source
and allow the unit to cool down before performing
any service or maintenance on the unit.
CAUTION
To prevent damage to the unit, do not use abra-
sive cleaners on the release sheet or belt wrap.
Figure 10. Removing/Installing Release Sheet
Heat Shield
Platen
Release Sheet