ROTHENBERGER ROWELD P250-630 B Plus Premium CNC - Manual (Page 52)

ENGLISH 50
P003 Heating plate temperature offset 5 °C -25 25 Welder
P004 Pmax for cutting 20 bar 10 50 Welder
P005 Target pressure 1/10 bar Welder
P006 Target temperature 210 °C P103 P104 Welder
P007 Timer T1 target value 45 sec 1 1500 Welder
P008 Timer T4 target value 6 min 1 99 Welder
P009 Pstart for cutting 10 bar 0 P004 Welder
P101 Deviation for repumping 5 % 1 50 Master
P102 Lifting time after cutting 10 1/10 sec 0 100 Master
P103 Set temperature (min) 160 °C 0 300 Master
P104 Set temperature (max) 270 °C 0 300 Master
P105 Button lock (yes/no) 5 sed 0 50 Master
P106 Lifting pressure 135 bar 10 160 Master
P107 Full runtime until buzzer goes on 50 1/10 sec 0 200 Master
P100 Change code 8001 Master
* P002 - Power saving function:
0 - none,
1 - when the miller is running the heating element will be switched off,
2 - when the hydraulic motor is running the heating element will be switched off,
3 - when t4 is running the heating element will be switched off.
3.6 Set date and time
 Close the program by clicking briefly in the upper left corner.
 Press Start, Setting and then Control Panel.
The taskbar is hidden and can be called back up by pressing on the lower left corner.