Nikon V3 - Manual (Page 61)

37
s
2 Remove the connector cap.
Remove the grip connector cap. Be
sure to replace the cap when the grip
is not in use.
3 Attach the grip.
After confirming that the camera is off, align the camera and
grip as shown and tighten the knob by rotating it in the
LOCK
2 direction, keeping the grip held in place so that the
grip signal contact slides straight into the camera grip con-
nector.
A Removing the Grip
To remove the grip, confirm that the camera is off and then loosen
the mounting screw by rotating the knob in the direction opposite
to that shown by the LOCK indicator.
D Handling the Grip
Do not touch the signal contacts. Failure to observe this precaution
could cause product malfunction.