Nikon D90 - Manual (Page 202)

182
L
d5: Screen Tips
Choose On (the default setting) to display tips for items selected in the shooting
information display, Off to turn tip display off. This option is available in all shooting
modes.
d6: CL Mode Shooting Speed
This option (available in all shooting modes) determines the maximum frame
advance rate in
! (continuous low speed) release mode. Choose from values
between one and four frames per second (fps); the default setting is 3 fps. Note that
the frame advance rate may drop below the selected value at slow shutter speeds.
d7: File Number Sequence
When a photograph is taken, the camera names the file by adding one to the last file
number used. This option (available in all shooting modes) controls whether file
numbering continues from the last number used when a new folder is created, the
memory card is formatted, or a new memory card is inserted in the camera.
D File Number Sequence
If the current folder is numbered 999 and contains either 999 photographs or a photograph
numbered 9999, the shutter-release button will be disabled and no further photographs can
be taken. Choose Reset for Custom Setting d7 (File number sequence) and then either
format the current memory card or insert a new memory card.
Option Description
On
When a new folder is created, the memory card formatted, or a new memory
card inserted in the camera, file numbering continues from the last number
used or from the largest file number in the current folder, whichever is higher.
If a photograph is taken when the current folder contains a photograph
numbered 9999, a new folder will be created automatically and file numbering
will begin again from 0001.
Off
(default)
File numbering is reset to 0001 when a new folder is created, the memory card
is formatted, or a new memory card is inserted in the camera. Note that a new
folder is created automatically if a photograph is taken when the current folder
contains 999 photographs.
J Reset
Same as for On, except that the next photograph taken is assigned a file
number by adding one to the largest file number in the current folder. If the
folder is empty, file numbering is reset to 0001.