beautypg.com

Spektrum SPMAR9200 User Manual

Page 14

background image

Spektrum AR9200

14

EN

Note: In order for the system to operate, all three remote receivers must be plugged

into the receiver in order for the receivers to bind and link to a transmitter.

It’s necessary to bind the AR9200 to the transmitter so that the AR9200 will

only recognize that specific transmitter, ignoring signals from any other

sources. If the PowerSafe Evolution is not bound to the transmitter, the system

will not operate. During binding the servo’s failsafe positions are stored.
How To Bind the PowerSafe Evolution

1. With the system hooked up and all remote receivers attached as

described previously, insert the bind plug in the DATA/BIND port in

the PowerSafe Evolution.

Binding

2. Turn on the PowerSafe Evolution with the SensorSwitch. Note that the

LEDs on all receivers should be flashing indicating that the receiver

is ready to bind.

3. Establish the desired failsafe stick positions, normally low throttle

and flight controls neutral.

4. Follow the procedures of your transmitter to enter it into bind mode.

The system will connect within a few seconds. The LEDs on all

receivers should go solid, indicating the system has connected.

5. Remove the bind plug and store it in a convenient place.
6. After you’ve programmed your model, it’s important to rebind the

system so the true low throttle and neutral control surface positions

are programmed.

This manual is related to the following products: