Allied Telesis AT-3714FXL - Manual (Page 30)

Installing the Switch
2-12
Figure 2-5 Connecting the 50-Pin Plug
6. Secure the MDA to the front of the switch with the 3 flathead Phillips
screws that came with the MDA package.
7. Apply power to the unit as follows:
Caution
Power cord is used as a disconnection device. To de-energise
equipment disconnect the power cord.
"
10
Re-attach the power cord to the unit and plug it in the wall outlet.
Verify that the Power LED lights green. See Table 2-1 on page 2-6.
8. Connect the data cable. Verify that the LEDs light.
Media Dependant
Adapter LEDs
The MDA LEDs are located on the front panel of the switch under
Port Activity.
For troubleshooting techniques, see Chapter 3, Troubleshooting.
POR
T A
100B
ASE-TX
10B AS 2X
AT-A10 100B
ASE-TX
X
Standoff
50-pin plug
Slot
Table 2-4 Media Dependent Adapter LEDs
LED Color State Description
Link Green On There is a good physical link with
a device.
Activity Green Flashing
or On The Ethernet port is receiving/
transmitting packets.