Allied Telesis AT-FS217 - Manual (Page 22)

Installing the Switch
12
Note
The switch can be mounted either vertically or horizontally.
5. Using the flanges under the fiber optic port as a guide, slide the switch
into the mounting bracket. Refer to Figure 6.
Figure 6 Sliding the Switch Over the Wall-mounting Bracket
6. Secure the switch to the wall-mounting bracket using the screws removed
in Step 2.
7. If your switch is shipped with Universal Voltage Power Adapter (2-cable),
do the following:
a. Connect the AC power cord to the Universal Voltage Power Adapter.
b. Plug the DC cable into the DC receptacle on the switch.
c. Plug the AC power cord on the adapter to a power outlet.
FX
TX
PWR
100M LK/AT
Fast Ether net Switch
AT-FS214
Flange Flange