Allied Telesis AT-8203 - Manual (Page 15)

AT-8202 and AT-8203 Installation Guide
9
Installing the Accelerator Card
Before following these procedures, make sure the uplink card is already
installed in the lower slot.
1. Using a #1 Phillips screwdriver, remove the screw that secures the
cover plate to the uplink panel (Figure 8).
Figure 8: Cover Plate Removal for Top PCI Slot
2. Insert the accelerator card into the top PCI slot and ensure that it is
fully seated. Line up the back edge of the accelerator card with the
card guide, as shown in Figure 9.
Figure 9: Accelerator Card Insertion
3. Seat the accelerator card firmly in the top PCI connector.
4. Using the screw from Step 1, secure the accelerator card to the chassis.