beautypg.com

Problem 1, Problem 2, Problem 3 – Allied Telesis AT-MR815T User Manual

Page 31: Is the link on lamp lighted

background image

AT-MR415T and AT-MR815T Installation Guide

21

Is The Link On Lamp Lighted?

The LINK ON lamps on the front of the repeater will light when a proper
connection between the corresponding 10Base-T port and the equipment
connected to it is established. If this lamp is not lighted, check for the
problems listed below and make corrections as necessary.

1. Problem 1:

The UTP (twisted pair) cable has been cut, damaged, or is the wrong type
of cable.

Solution:

Try making the connection with a different cable. Be sure you are using an
undamaged cable of the correct type.

2. Problem 2:

Connected equipment is not turned on or not operating properly.

Solution:

Check the connected equipment (computer, another repeater, etc.) and turn
on the power.

3. Problem 3:

The MDI MDI-X toggle switch of the AT-MR415T/AT-MR815T Micro
Repeater
is on the wrong setting.

Solution 3:

When using the cascade port of the AT-MR415T/AT-MR815T Micro
Repeater
, the switch should be set to MDI; otherwise, the switch should be
in the MDI-X position. When cascading two AT-MR415T/AT-MR815T
Micro Repeaters
, the unit using the cascade port should have the switch set
to MDI, while the other unit should have its switch set to MDI-X.

When port 4 of the AT-MR415T or port 8 of the AT-MR815T are not
connected to another repeater, but are used to connect to a computer or
other equipment, the MDI MDI-X toggle switch should be set to MDI-X.

This manual is related to the following products: