Allied Telesis AT-MC104LH - Manual (Page 17)

11
Appendix A
Electrical Safety and Installation
Requirements
STANDARDS: This product meets the following standards
STANDARDS: This product meets the following standards
!
1 RFI Emission EN55022 Class A
! 2 WARNING: In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
! 3 Immunity EN50082-1 1997
Electrical Safety TUV-EN60950, UL1950, CSA 950
Laser EN60825
Warning Class 1 Laser product.
! 4 Warning Do not stare into the Laser beam.
At time of installation, the Fiber Optic Lasers comply with FDA Radiation Performance Standard 21CFR
Subchapter J, applicable at date of manufacture. Use of controls or adjustments of performance or
procedures other than those specified herein may result in hazardous radiation exposure.
SAFETY
! 5 LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of LIGHTNING ACTIVITY.
! 6 DO NOT BLOCK AIR VENTS
Power to the hub must be sourced only from the adapter.
USA/CANADA
Use a UL Listed/CSA Certified AC adapter of DC 12V, 500mA.
EUROPE - EU
Use TÜV licensed AC adapter of DC 12V, 500mA.
UK
Use a UK Safety Approved AC adapter of DC 12V, minimum 500mA.
OPERATING TEMPERATURE
This product is designed for a maximum ambient temperature of 40 degrees C.
ALL COUNTRIES: Install product in accordance with local and National Electrical Codes.
U.S. Federal Communications Commission
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
this instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your
right to operate this equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.