Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT - Manual (Page 89)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
PN 613-50507-00 Rev C Page 89 of 224
Address Table
Displays the list of IP interfaces and their IP addresses on the router.
Note - The Address Table sub-menu option does not display the correct parameters. Instead,
it displays the sub-menu option name as a parameter with a value of 'noSuchName'.
Route Table
Displays the IP routing table on the router.
Note - The current firmware version does not allow the user to configure the Destination Port
Number parameter. Attempting to configure this parameter will result in the error messages:
"The error occurred with 'Set' operation. Error: gen Error." or "The error occurred with 'Set'
operation. Error: bad value."
Note - The current firmware version does not allow the following parameters to be
configured:
• Destination Metric 1
• Destination Metric 2
• Destination Metric 3
• Destination Metric 4
• Next Hop Address
• Routing Type
• Route Updated Seconds
• Routing Mask
• Destination Metric 5
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error."
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status and the Default
TTL parameters to be configured. Attempting to configure these will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
ICMP Statistics
Displays ICMP statistics.
UDP Statistics
Displays UDP statistics.
TCP Statistics
Displays TCP statistics.