Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT - Manual (Page 79)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
PN 613-50507-00 Rev C Page 79 of 224
inactive ports to 'blocking'. As a result, expect port images for inactive ports to turn yellow in AT-
View Plus Device Manager.
Note - When a port on the AT-9410GB is set to 'auto sense' and is connected to a half-duplex port on
another device, its corresponding Duplex LED on the device image turns green instead of orange.
Note - Connection cannot be established between a GBIC port that is configured to auto-negotiate
and a port on another device that is configured to operate at 1Gbps full/half duplex.
Note - A GBIC image is always visible on each of the GBIC slots of the device image even if there
are no GBICs physically inserted.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log into the
CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and description.
Note - The current firmware version does not allow the user to enter multiple-word values for
the System Name parameter.
Note - AT-View Plus Device Manager allows the user to enter up to 255 characters for the
System Contact, System Name, and System Location parameters but truncates them to 64
characters.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway and the
agents.
Note - The current firmware version does not save changes made to the DNS Server and the
Default Domain Name parameters.
DHCP Info
Displays DHCP information including the DHCP System Group and DHCP Timer Group.
Manager Address Info
Displays the IP address of the management station.
Reset
Resets the switch.