Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT - Manual (Page 67)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
PN 613-50507-00 Rev C Page 67 of 224
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Note - Ports are numbered continuously from top to bottom, across all installed line cards, starting
from the leftmost line card all the way through the rightmost line card. This applies to the following
submenu options:
• Utilization
• Interface Info -> Standard
• Error Statistics -> Standard
• Spanning Tree Info
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on the port,
bytes received and transmitted on the port, and port status.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value.".
Error Statistics
Displays error statistics such as alignment error frames and carrier sense errors.
Detail Info
Displays detailed port information such as duplex mode.
Note - The current firmware version does not allow the Port Name parameter to be set to
NULL. Attempting to set this parameter to NULL will result in the error message: "The error
occurred with 'Set' operation. Error: bad value.".
Spanning Tree Info
Displays the port's spanning tree parameters.
Note - The current firmware version does not allow the Port parameter to be configured.
Attempting to configure this parameter will result in the error message: "The error occurred
with 'Set' operation. Error: readOnly".