Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT - Manual (Page 81)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
PN 613-50507-00 Rev C Page 81 of 224
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on 'down'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
Detail Info
Displays detailed port information such as duplex mode.
Note - A twisted pair port that is configured to operate at 1Gbps half-duplex will not be able
to establish a link with a port on another device that is also configured to operate at 1Gbps
half-duplex. However, expect the Port Link State parameter to return the value 'on-line'.
Note - A twisted pair port that is set to 'auto sense' will not be able to establish a link with a
port on another device that is configured to operate at 1Gbps full/half duplex. However,
expect the Port Link State parameter to return the value 'on-line'.
Note - The Port Name parameter is not applicable to the AT-9410GB.
Note - The current firmware version does not allow the Port VLAN Tag Priority parameter to
be configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Note - The Port Transmit Pacing Configuration parameter is not applicable to the AT-
9410GB.
Note - The current firmware version does not allow the Port Speed and Mode parameter of
the 1000BASE-X GBIC port to be set to other value except for 1Gbps Full/Half-duplex.
Note - AT-View Plus Device Manager allows the user to disable an active port. However, the
disabled port's Port Link State parameter retains the value 'on-line'.