Allied Telesis AT-S63 - Manual (Page 599)

AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Internet Protocol Routing 599
– BOTH: both version 1 and 2 packets
ˆ Auth - The form of authentication. Possible settings are:
– NONE: no password authentication
– PASS: plaintext password authentication
ˆ Password - The authentication password, displayed with asterisks. A
value of NOT SET in this column indicates the interface does not have
a password for RIP.
To add RIP to an interface, refer to “ADD IP RIP” on page 572. To modify
the RIP settings of an interface, refer to “SET IP RIP” on page 586.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command displays the RIP settings for all of the interfaces where RIP
has been added:
show ip rip
This command displays the RIP settings of the VLAN17-2 interface:
show ip rip interface=vlan17-2
The command does not display anything if the VLAN17-2 interface does
not have RIP.