Allied Telesis AT-S63 - Manual (Page 572)

Chapter 32: Internet Protocol Version 4 Packet Routing
572 Section VII: Internet Protocol Routing
ADD IP RIP
Syntax
add ip rip interface= interface [send=rip1|rip2]
[receive=rip1|rip2|both] [authentication=pass|none]
[password=
password ]
Parameters
interface Specifies the name of the routing interface where RIP
is to be added. The name consists of “VLAN” followed
by a VID and an interface number, separated by a
dash (e.g., vlan4-0). For background information,
refer to “Interface Names” on page 550.
send Specifies the version of RIP packets to be sent by the
routing protocol. Options are:
rip1 Sends RIP version 1 packets. This is the
default value.
rip2 Sends RIP version 2 packets.
receive Specifies the version of RIP packets to be accepted
by the routing protocol. Options are:
rip1 Accepts RIP version 1 packets.
rip2 Accepts RIP version 2 packets.
both Accepts RIP version 1 and 2 packets.
This is the default value.
authentication Specifies whether there is password protection. This
option only applies to RIP version 2. Options are:
pass Specifies password protection. The
password is assigned with the
PASSWORD parameter.
none Specifies no password protection. This is
the default setting.
password Specifies the password used to authenticate RIP
version 2 packets. The password can be up to sixteen
alphanumeric characters. The password is case
sensitive and can include the hyphen and
underscore.