ADT Security Services ADT-UDACT - Manual (Page 51)

Document 50934 Rev B 5/15/00 PN 50934:B 51
Appendix C: Point Assignments (ADT-MNNA)
Point No. Point Function Point No. Point Function Point No. Point Function
1 41 81
2 42 82
3 43 83
4 44 84
5 45 85
6 46 86
7 47 87
8 48 88
9 49 89
10 50 90
11 51 91
12 52 92
13 53 93
14 54 94
15 55 95
16 56 96
17 57 97
18 58 98
19 59 99
20 60 100
21 61 101
22 62 102
23 63 103
24 64 104
25 65 105
26 66 106
27 67 107
28 68 108
29 69 109
30 70 110
31 71 111
32 72 112
33 73 113
34 74 114
35 75 115
36 76 116
37 77 117
38 78 118
39 79 119
40 80 120
Note: Use the following charts to carefully identify the function of each point in the system. Take special precaution with any
supervisory points in the system. For the ADT-UDACT to report a supervisory point to the central station, both the FACP and the
ADT-UDACT must have the point programmed as supervisory. Failure to program the panel or ADT-UDACT correctly will result
in a fire alarm signal being transmitted to the central station. All points greater than 568 can only be transmitted as fire alarm
points. Use Type Mode (refer to Section 4.2 Type Mode) to match the function of points in the system for proper reporting.