Allied Telesis AT-WCC201G - Manual (Page 17)

AT-WCC201G Wireless Adapter Card Installation Guide
17
Installing the Adapter Driver
To install the adapter driver, perform the following procedure:
1. Power ON the computer.
2. Insert the Software and Documentation CD into the CD drive of the
computer.
Note
If your computer launches the web browser when you insert the CD,
minimize or close the web browser window.
3. Connect the AT-WCC201G wireless adapter to a Type II CardBus slot
on the computer. Be sure to fully seat the adapter in the slot.
Windows detects the new adapter and launches the Found New
Hardware Wizard. The first window of the wizard is shown in Figure 2.
Figure 2. Found New Hardware Wizard Window (1 of 3)
Note
If the window does not appear, disconnect and reconnect the
AT-WCC201G adapter to the computer.