Allied Telesis AT-EN646MOD Enclosure - Manual (Page 29)

AT-EN646MOD Installation Guide
Chapter 3: Enclosure Installation 29
Secure the Optical Wire
Note
It is critical that you maintain a minimum fiber bend radius of 1 in. when you route the fiber optic
cables and mount them to the enclosure with the self-adhesive wire clips.
1. Connect the optical fiber and pigtail to the back of the enclosure with adhesive clips, as shown in Figure
25.
2. Place the optical fiber over each fiber clip on the grounding plate, push it down into the clip, and twist to
retain the fiber.
3. Ensure the pigtail forms a continuous curve of the same angle through the fiber clips and where it will
plug into the iMG646MOD unit. Again, refer to Figure 25
Figure 25. Routing the Optical Wire through the Clips
4. The Enclosure is now complete and should be locked up for later Electronics installation. Refer to Figure
26.