Allied Telesis AT-EN646MOD Enclosure - Manual (Page 26)

AT-EN646MOD Installation Guide
26 Chapter 3: Enclosure Installation
8. Route the buffer tube from the drop cable to the upper left corner of the splice tray and secure the tube
to the splice tray with the wire tie.
9. Just beyond the tie, strip the buffer tube away. Refer to Figure 21
.
Figure 21. Securing the Buffer Tube
10. Route the fiber cable 2 times around the splice tray to the splice organizer and cut it to a length that will
allow the splice to the pigtail be placed in the organizer, as shown in Figure 22.
Figure 22. Setting the Fiber Cable in the Splice Tray
11. Cut the SC/UPC pigtail cable (not provided) 30 in. (77 cm) beyond the boot.