Allied Telesis AT-EN646MOD Enclosure - Manual (Page 27)

AT-EN646MOD Installation Guide
Chapter 3: Enclosure Installation 27
12. Strip the SC/UPC pigtail jacket to expose 22.75 in. (58 cm) of fiber.
13. Clean the fiber, and splice it to the pigtail, per the splicer manufacturer’s instructions.
14. Route the pigtail once around the splice tray and out through the lower right corner, as shown in
Figure 23.
Figure 23. Securing the Pigtail
The pigtail should extend 15.5 in. (40 cm) from the splice tray.
15. Trim the wire tie close to the cables. The completed splice tray should look like Figure 24.