Allied Telesis AT-EN646MOD Enclosure - Manual (Page 23)

AT-EN646MOD Installation Guide
Chapter 3: Enclosure Installation 23
Install the Ground Wire
The AT-iMG646MOD must be connected to a good earth ground.
Caution
Install all electronics equipment as per state and local ordinances.
To install the ground wire, perform the following procedure:
1. Prepare an adequate length of 14AWG stranded grounding wire for the ground connection.
1. Strip 0.25 in. (0.7 cm) of insulation from the ground wire and crimp it into a ground wire ring lug sized for
a 10-32 post.
2. Remove the Kepnut from the ground wire post.
3. Secure the ground wire ring lug on the ground wire post using the Kepnut, as shown in Figure 18.
Figure 18. Lining Up the Ground Wire