Allied Telesis AT-FS750/48 - Manual (Page 43)

AT-FS750/48 Fast Ethernet Smart Switch Installation Guide
43
Figure 16. Plugging in the AC Power Cord
2. Plug the other end of the power cord into a wall outlet.
3. Verify that the POWER LED is green. If the LED is off, refer to Chapter
3, “Troubleshooting” on page 45.
The switch is now powered on and ready for network operations. To
start a local management session on the switch, refer to “Starting a
Management Session” on page 44.
1012
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
8
Pluggable Equipment. The socket outlet shall be installed near
the equipment and shall be easily accessible.
10