Allied Telesis AT-FS750/48 - Manual (Page 42)

Chapter 2: Installation
42
Connecting the
Fiber Optic
Cables
To connect a fiber optic cable to an SFP installed in the AT-FS750/48 Fast
Ethernet Smart switch, perform the following procedure:
1. Remove the dust plug from the SFP, as shown in Figure 14.
Figure 14. Removing the Dust Plug from the SFP
2. Connect the fiber optic cable to the SFP port, as shown in Figure 15.
Figure 15. Connecting the Fiber Optic Cable
Powering On the
Switch
To power on the switch, perform the following procedure:
1. Plug the power cord into the AC power connector on the back of the
switch, as shown in Figure 16.
1013
1011