Allied Telesis Telesyn AlliedView NMS System 9.0 - Manual (Page 22)

Installing on a Windows Platform Initial Installation on a Front End Server
AlliedView NMS Installation Guide (Installing the AlliedView NMS - Distributed Front End
Server) 3-2
Note: The Front-End configuration is available only upon request. Please contact your Allied Telesis
representative for details.
Note: Anonymous FTP is used by the NMS to manage certain devices, and therefore must be
enabled on the Backend server. Refer to Appendix A for instructions.
3.2 Installing on a Windows Platform
Note: Prior to beginning the installation, obtain the IP address for the existing AlliedView NMS Back
End Server.
3.2.1 Initial Installation on a Front End Server
The software for a Front End server installation comes in a separate CD, and so can only be used to install a
Front End server. To install the AlliedView NMS Front End on a Windows platform, follow these steps:
1. Insert the Distributed Server Extensions installation CD-ROM in the CD-ROM drive. After approximately
60 seconds, the NMS InstallShield
1
Wizard Installer screen will appear.
2. On the Installer screen, click Next. This will display the license agreement page.
3. Carefully read the license agreement, click the I accept the terms of the license agreement radio button,
and then click Next.
Note: If you do not wish to proceed with the installation, click Cancel to exit.
The next screen, shown in the following figure, will specify the installation directory.
1. Registered Trademark ® 2003 InstallShield Software Corporation. All rights reserved.