Allied Telesis AT-2973T (NetExtreme II) - Manual (Page 87)

AT-2973SX and AT-2973T NetExtreme II Family Adapters Installation and User’s Guide
87
Once located, notice the following information:
[params_utp]
hkr, , req_medium, 2, "0"
[params_fiber]
hkr, , req_medium, 2, "65283"
These make up two separate sections that can be configured: one for
standard RJ-45 copper interfaces (params_utp) and one for fiber
devices (params_fiber).
3. As described in the file, replace the value above in quotation marks
under the correct section, depending upon the network adapter in your
system. The available values are shown below.
Options for copper interfaces:
– Auto (1 Gbps is enabled when that speed is
supported) = "0"
– 10 Mbps Half Duplex = "65794"
– 10 Mbps Full Duplex = "258"
– 100 Mbps Half Duplex = "66050"
– 100 Mbps Full Duplex = "514"
Options for fiber interfaces:
– Auto (1 Gbps is enabled when that speed is
supported) = "0"
– 1 Gbps Full Duplex = "771"
– Auto with 1 Gbps Fallback = "33539"
– Hardware default = "65283"
An example is provided in the file showing how to configure a copper
interface for a 10 Mbps Full Duplex connection. The example is shown
below.
– hkr, , req_medium, 2, "258"