Allied Telesis AT-2973T (NetExtreme II) - Manual (Page 82)

Chapter 6: Installing the Windows Drivers
82
Removing the Device Drivers
This section discusses how to remove the device drivers.
Note
Windows Server 2003 and Windows Server 2008 provide the
Device Driver Rollback feature to replace a device driver with one
that was previously installed. However, the complex software
architecture of the NetXtreme II device may present problems if the
rollback feature is used on one of the individual components.
Therefore, Allied Telesis recommends that changes to driver
versions be made only through the use of a driver installer.
To remove the device drivers, do the following:
1. In Control Panel, double-click Add or Remove Programs.
2. Click Broadcom NetXtreme II GigE Driver Installer, and then click
Remove. Follow the on screen prompts.
3. Click Yes to restart your system.
- or -
4. Click No to restart your system at a later time. Click OK to
acknowledge that the installation has been suspended. The
uninstallation of the driver is postponed until the next restart of your
system.