Allied Telesis AT-GS2002/SP - Manual (Page 44)

Chapter 2: Installation
44
3. Plug the AC/DC adapter to a power outlet, as shown in Figure 12.
Refer to Appendix A, “Technical Specifications” on page 49 for power
requirements.
Figure 12. Plugging an AC/DC Adapter to a Power Outlet
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
 5
4. Verify that the PWR LED on the front of the converter is green. If the
LED is OFF, refer to “Troubleshooting” on page 45 for instructions.
5. Verify that the LINK LEDs for both the SFP port and the twisted-pair
port are green. If either LED is OFF, refer to “Troubleshooting” on
page 45 for instructions.
The chassis is now ready for network operations.