Maximum Wireless Maestro (2006-2012) - Manual (Page 4)

11
Z-SHAPED ARM
WIRELESS
TRANSMITTER
LOCKING
BRACKET
ALIGNMENT
HOLE
STAINLESS-STEEL
STAINLESS-STEEL
MOUNTING SCREWS
ALIGNMENT SCREW
STAINLESS-STEEL
MOUNTING SCREWS
Mount the Wireless Wind Transmitter to the “Z” shaped
arm. Remove the four stainless steel screws holding the
locking bracket. Place the transmitter over the arm as
shown. Insert one stainless steel screw through the
center of the locking bracket and into the alignment hole
in the z-shaped arm. Re-attach the locking bracket
with the four remaining stainless steel screws.
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 4
MAESTRO
INSTALLATION
WIRELESS
WIND SPEED
INDICATED
ON DIAL
9
WIND
DIRECTION
LIGHTS
Perform a test of your wireless MAESTRO. Spin the cups on
the wind sensor and a speed should be indicated on the dial
(there will be a brief delay). Slowly rotate the vane on the wind
direction sensor and the lights indicating wind direction should
change (again, there will be a brief delay).
If the above tests do not produce the results described, refer
to the trouble-shooting section at the back of this manual for
assistance.
10
Replace the plastic battery cover. Make
sure to seat the cover properly over the
glued in gasket.
1000
1000
cover