Maximum Wireless Maestro (2006-2012) - Manual (Page 2)

MAESTRO
INST TION ALLA
WIRELESS
WHITE
ORANGE
RED
GREEN
TRANSMITTER WIRING
4
BOSS
4 2
3
1
WHITE
BOOT
5
SMALL HOLE
IN BOOT
ORANGE
BLACK
RED
GREEN
5-CONDUCTOR
CABLE
WIRELESS
TRANSMITTER
BRASS
NUT
PIN
WIND SPEED
SENSOR
5
STRAIGHT
STUB MAST
2-CONDUCTOR
CABLE
COTTER
Slide the straight stub mast through the black rubber
boot and insert it into the Wind Speed Sensor, securing
it with the supplied stainless steel cotter pin. Once the
final installation is made and proper function is verified,
coat all the wire connections with a silicone sealant
designed for electrical connections (not supplied). Slip
the boot over the base of the sensor.
BOOT
WIND DIRECTION
SENSOR
COTTER
Z-STUB
MAST
5-CONDUCTOR
CABLE
#3
TERMINAL
ALIGNED
OVER
MAST
BOOT
PIN
6
Slide the “Z” shaped mast through the black rubber boot and
insert it into the Wind Direction Sensor. Align the sensor so
that the number 3 terminal is located over the horizontal
section of the “z” shaped mast and secure it with the supplied
stainless steel cotter pin. Once the final installation is made
and proper function is verified, coat all the wire connections
with a silicone sealant designed for electrical connections
(not supplied). Slip the boot over the base of the sensor.
ORANGE
RED
GREEN
WHITE WHITE .............to...............TERMINAL #1
.........to...............TERMINAL #2
............to...............TERMINAL #3
.................to...............TERMINAL #4
............to...............TERMINAL #5
BLACK
ORANGE
RED
GREEN
Feed the terminal lug end of the five-conductor cable
through the other rubber boot and connect the lugs to
the terminals on the bottom of the wind-direction sensor
with the brass nuts from the Hardware Pack. Do NOT
adjust the nuts that are already on the sensor.
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 2
Align the sensor so that the number 3 terminal is located
over the horizontal section of the “z” shaped mast