Maximum Wireless Merlin, Mystic & Rainwatch (pre-2006) - Manual (Page 4)

3. Wind Transmitter (cont.)
- Remove the bottom portion of the black bracket on the back of the Wind
transmitter case, by loosening the four black screws.
- Place the Wind transmitter case on the horizontal section of the formed wind
direction mast with the antenna situated above the mast arm.
- Place the bottom portion of the black bracket behind the mast arm and secure
it in place with the four black screws that were removed.
- Secure both sensor stub masts to your antenna mast (not supplied) with the
two hose clamps provided.
- Open the Wind transmitter case by lifting the two thumb latches, and place the
circuit board Jumper in the test position (
see Diagram C ). This will ensure that
the Receiver recognizes the Wind transmitter when batteries are eventually
inserted.
Jumper
Normal Position
Test Position
Diagram C
IV. Transceiver Testing & Sensor Installation (please follow directions in the order shown)
A. Instrument Display
- Move the instrument display and the individual sensors nearby the desired
installation location (the display may lie on a table or floor for testing purposes).
o This step is necessary to determine whether or not proper signals can
be obtained for each component, prior to final installation.
- Connect the AC adaptor(s) provided, to the instrument(s).
o If you have more than 1 instrument, wire 1 AC adaptor to each
instrument.
- Plug in all the AC adaptors.
SOLDER SIDE