Maximum Wireless Merlin, Mystic & Rainwatch (pre-2006) User Manual
Page 2
A. Receivers (cont.)
2. Rainwatch
-
Connect the Yellow wire from the receiver to terminal #4 of the Rainwatch.
-
Connect the Brown wire from the receiver to terminal #5 of the Rainwatch.
B. Transmitters
1. Temperature
-
The Temperature transmitter operates on two AA Alkaline batteries (supplied).
o
Do Not install the batteries yet.
-
Open the thumb-latch on the Temperature transmitter case, and place the
circuit board Jumper in the test position (
see Diagram A
). This will ensure that
the Receiver recognizes the Temperature transmitter when batteries are
eventually installed.
Jumper
Normal Position
Test Position
Diagram A
2. Rain Transmitter
-
The Rainfall transmitter operates on two AA Alkaline batteries (supplied).
o
Do Not install the batteries yet.
-
Remove the top of the Rain Collector by loosening the four Phillips head
screws and rotating the top counter-clockwise.
-
Remove the blue cover to access the circuit board, and place the circuit board
Jumper in the test position (
see Diagram B
). This will ensure that the Receiver
recognizes the Rainfall transmitter when batteries are eve ntually installed.
BOTTOM