Wesley BC-6200-8SA - Manual (Page 37)

Curtis 1268 Manual, Rev. D
31
4 — INSTALLATION CHECKOUT
4
☞
C A U T I O N
INSTALLATION CHECKOUT
Before operating the vehicle, carefully complete the following checkout proce-
dure. If you find a problem during the checkout, refer to the diagnostics and
troubleshooting section (Section 6) for further information.
The installation checkout can be conducted with or without a program-
mer. The checkout procedure is easier with a programmer. Otherwise, observe
the Status LED (located in the controller’s label area) for diagnostic codes. The
codes are listed in Section 6.
Put the vehicle up on blocks to get the drive wheels
up off the ground before beginning these tests.
Do not stand, or allow anyone else to stand, directly
in front of or behind the vehicle during the checkout.
Make sure the keyswitch is off, the throttle is released,
and the forward and reverse switches are open.
Wear safety glasses and use well-insulated tools.
1. If a programmer is available, connect it to the programmer connector.
2. Turn the run/store switch on. The programmer should power up with
an initial display. If it does not, check for continuity in the run/store
switch circuit and controller ground.
If a programmer is not available, controller power-up can be veri-
fied by momentarily selecting reverse and listening for the sound of the
reverse alarm.
3. If you are using a programmer, go to the Faults Menu. The display
should indicate “No Known Faults.”
If there is a problem, the LED will flash a diagnostic code and the
programmer will display a diagnostic message. If you are conducting
the checkout without a programmer, look up the LED diagnostic code
in Section 6: Diagnostics and Troubleshooting.
When the problem has been corrected, it may be necessary to cycle
the run/store switch in order to clear the fault.
4. Turn the keyswitch on, select a direction, and operate the throttle.
The motor should begin to turn in the selected direction. If it turns in
the wrong direction, first verify the wiring to the forward and reverse
switches. If the direction switch wiring is correct, turn off the controller,