Campbell Scientific UT20 and UT30 Tower-based Weather Stations - Manual (Page 13)

UT20 and UT30 Tower-based Weather Stations
3.3 Tools Required
Tools required to install and maintain a weather station are listed below.
3.3.1 Tools for Tower Installation
Shovel
Rake
Open end wrenches: 3/8 in, 7/16 in, 1/2 in, (2) 9/16 in
Magnetic compass
Step ladder (6 ft)
Tape measure (12 to 20 ft)
Nut driver (3/8 in)
Level (36 to 48 in)
Small sledge hammer
Pliers
Tie wire
Climbing harness
Hard hat
Haul rope (50 ft)
Non-stretch line (20 ft)
Wire rope cutters
Materials for B18 Base and UTEYE Anchors:
(4) Wood stakes (12 in)
Pick or digging bar
Concrete form materials (2 x 4 in lumber, stakes, saw, hammer, nails, etc.)
Concrete trowel and edger
Materials for UTDUK Duckbill Anchors
Sledgehammer
Highlift jack
Chain (to attach jack to anchor loops)
Materials for RFM18 Base:
(4) anchors appropriate for mounting surface
(4) bolts and washers to secure base to anchors
3.3.2 Tools for Instrumentation and Maintenance
Lock and key for enclosure
Magnetic declination angle (Section 8.5, Sensor Installation)
Magnetic compass
Straight bit screwdrivers (small, medium, large)
Phillips-head screwdrivers (small, medium)
Small diagonal side-cuts
Needle-nose pliers
Wire strippers
Pocket knife
Calculator
Volt / Ohm Meter
Electrical Tape
Step ladder (6 ft)
Datalogger prompt sheet (Section 9, Maintenance and Troubleshooting)
Station manuals
Station log and pen
Open end wrenches: 3/8 in, 7/16 in, 1/2 in, (2) 9/16 in
Socket wrench and 7/16 in deep well socket
Adjustable wrench
3