Campbell Scientific TX312 High Data Rate GOES Transmitter - Manual (Page 85)

Appendix G. Extended ASCII Command Set
G-13
2,+348.5,-23.97,-55.7[CR][LF]
1,+3.24,-2.789,///,///[CR][LF]
5,-46,+86,+23.4[CR][LF]
2,+344.5,-28.88,-77.7[CR][LF]
1,+3.55,-2.733,///,///[CR][LF]
5,-24,+86,+25.4[CR][LF]
2,+645.5,-24.88,-77.7[CR][LF]
If FC=1 the format is the same except that each record is preceeded by a 24
hour time stamp with the format hh:mm:ss. The time stamp is always in 24
hour form and referenced to UTC.
This parameter is saved to non-volatile memory using the SAVE command and
is part of the configuration read back with the RCFG command.
G.4.7 Set SDI Sample Interval
Syntax:
SIN=hh:mm:ss
Access level: USER
TX312 State: Enabled/Disabled
Sets the sample interval for all SDI-12 sensors. If the interval is set to a value
less than the time required to perform all the SDI-12 measurements, the
measurements will be performed continuously. Setting the value to 00:00:00
effectively disables SDI-12 data collection.
Valid range is 00:00:00 to 23:59:59.
This parameter is saved to non-volatile memory using the SAVE command and
is part of the configuration read back with the RCFG command.
G.4.8 Set SDI Sample Interval Offset
Syntax:
SOF=hh:mm:ss
Access level: USER
TX312 State: Enabled/Disabled
Sets the sample interval offset for all SDI-12 sensors.
Valid range is 00:00:00 to 23:59:59.
This parameter is saved to non-volatile memory using the SAVE command and
is part of the configuration read back with the RCFG command.