Campbell Scientific TX312 High Data Rate GOES Transmitter - Manual (Page 58)

Appendix D. RAWS-7 Data Format
D-10
45: Sample (P70)
1: 1
Reps
2: 10 Loc [ Avg10WS ]
46: Sample (P70)
1: 1
Reps
2: 11 Loc [ Avg10WD ]
47: Sample (P70)
1: 1
Reps
2: 3 Loc [ AirTemp ]
48: Sample (P70)
1: 1
Reps
2: 7 Loc [ FuelT ]
49: Sample (P70)
1: 1
Reps
2: 4 Loc [ RH ]
50: Minimum (P74)
1: 1
Reps
2: 0 Value Only
3: 1 Loc [ BattVolt ]
; Send the basic RAWS-7 data to the SAT HDR GOES 5 minutes before transmit time.
; FS 1 must contain only the new RAWS-7 data, 3 hours of data.
51: If time is (P92)
1: 65
Minutes (Seconds --) into a
2: 180 Interval (same units as above)
3: 30 Then Do
; P126 set to "insert" data to "self-timed" buffer.
; Insert will erase the buffer before sending the
; new RAWS-7 data.
52: Data Transfer to HDR GOES (P126)
1: 1
Self Timed/Insert
2: 3 ASCII RAWS-7 Format
3: 14 Result Code Loc [ P126_RC ]
53: End (P95)
; ***********************************************
; Calculate and hold data beyond the RAWS-7 data.
; ***********************************************
; Four additional data values are written.
; Must create a table, one column for each hour.
; Each column has 4 data points:
; Direction of Max wind speed, Max wind speed,
; Ave Solar Radiation, fuel moisture.
; Solar radiation is in high resolution format.